Working Conditions And Operation Of Cartridge Heater Electric Heaters Note

Nov 09, 2024 Leave a message

1,the working conditions of the cartridge heater electric heating element

cartridge heater electric heater has no special requirements for the temperature of the working environment, but the humidity of the air in the environment can not be greater than 95%, and there can be no flammable, explosive or corrosive gases. cartridge heater electric heater external working voltage can not exceed the rated voltage of 1.1 times, before the operation of the electric heater must ensure that the shell is effectively grounded to avoid electrical accidents.

2,Operation of cartridge heater electric heater note

cartridge heater electric heater for heating easy to melt metal or solid nitrate, paraffin, asphalt and other substances, to melt the heated material first, then you can reduce the external voltage of the heater, when the melting is complete and then return to the rated voltage. In addition, when heating nitrate salt and other substances that are prone to explosive accidents with a cartridge heater electric heater, safety measures should be fully considered. cartridge heater electric heater for air heating, pay attention to its uniform arrangement, the advantage of doing so is to ensure that the cartridge heater electric heater has a more adequate and uniform heat dissipation space, and as far as possible to ensure the mobility of the air, improve its heating efficiency, cartridge heater electric heater internal gap filled with magnesium oxide sand, magnesium oxide sand in the outlet end of the line is easy to be contaminated because of the impurities and moisture seeping in, so pay attention to the operation when the Outlet end of the state, to avoid the leakage accident caused by the cartridge heater electric heater must be kept dry and proper storage of insulation yin, if the use of cartridge heater electric heater found in the storage environment insulation yang is too small, can be low voltage to be restored to the power to be used again. cartridge heater electric heater should be properly fixed before use, the wiring part should be placed outside the insulation, and avoid contact with corrosive, explosive media and water. cartridge heater electric heater for liquid or metal solid heating, pay attention to the whole branch must be completely placed into the object to be heated, do not allow the cartridge heater electric heater empty burning situation. cartridge heater electric heater after use if the outer layer of the Jinying shell with scale or carbon, it is necessary to remove it in a timely manner, in order to avoid the impact on the heat dissipation performance and service life of the cartridge heater electric heater.