Composition Of Rtd Temperature Measurement System

Dec 07, 2024 Leave a message

(1) The RTD temperature measurement system generally consists of RTDs, connecting wires and display instruments. The following two points must be noted:
① RTD and display instrumentation must be the same graduation number
② In order to eliminate the influence of the resistance change of the connecting wire, three-wire connection method must be used. See Chapter 3 for details.
(2) Armoured RTD Armoured RTD is a solid body combined with temperature sensing element (resistance body), lead wire, insulating material and stainless steel casing, and its outer diameter is generally φ2~φ8mm, and the smallest one can be up to φmm. Comparing with the common type RTD, it has the following advantages:
① small volume, no air gap inside, thermal inertia, measurement hysteresis is small;
② Good mechanical properties, vibration resistance, shock resistance;
③can be bent, easy to install
(iv) Long service life.
(3) End-face RTD End-face RTD sensing element is made of specially treated resistance wire, which is tightly affixed to the end face of the thermometer. Compared with the general axial RTD, it can reflect the actual temperature of the measured end face more correctly and quickly, and is suitable for measuring the end face temperature of the axial tile and other parts.
(4) Explosion-proof type RTD Explosion-proof type RTD through a special structure of the junction box, the shell of the internal explosive mixture of gases due to sparks or arcs and other shadows Resistor break repair is bound to change the length of the resistance wire and the impact of the resistance value, for this reason, the replacement of the new resistor body is good, if the welding repair, welding to be calibrated after passing before use.