The Use Precautions and Maintenance Details of Electric Tube Heater:
Before ordering the heating tube, please ensure that you will use electric tube heaters to heat air or water. So we can avoid the unit area of heat load is too large to allow the heating temperature to damage the heating tube. In addition, the wiring leads to the part of the heater should be exposed in the insulation layer or heater, so that this part should not be overheated and damaged.
The input power supply voltage can not exceed 10% higher than the rated voltage marked on electric tube heater, otherwise likely to cause accidents. And the input voltage should not be less than the rated voltage, otherwise the heat generated by the heat pipe will also decline.
Electrothermal pipe terminals should be kept clean and dry, otherwise it will reduce the insulation performance and have short-circuit breakdown. If the electric tube heater is used chemical corrosion, flammable, explosive and other liquid or gas environment, the heating tube wiring part should be sealed strictly to prevent accidents.
When use electric tube heaters to heat some of the viscose and other substances, such as sodium nitrate, stearic acid, paraffin, etc. The voltage and power should be low to reduce the heat of electric heat tube at the beginning. Until all the material is melted into liquid, the voltage can be rised to rated voltage for heating.
When you choose electric tune heater' material, please pay special attention to heating medium to avoid the media erosion of electric shell material.
After using electric tube heaters after a period of time, if the surface of heater body has thick scale and grease,they should be regularly removed. Otherwise it will reduce the heat transfer performance, and make tube surface heat load exceed the rated. It will damage the electric tube heater and shorten heaters' use lifetime.
The Electric tube heaters should be stored in a dry warehouse. If the surface is damped because of long time store, the insulation resistance should be measured in megger before use. If less than 1 megohm / 500 volts, the electric tube heaters should be placed at 200℃ box for drying again.
