The guitar bending heaters can be used a couple of ways to bend sides to shape. One way is to use a side bendingblanket with a bending jig. Merely sandwich the unbent side, along with the heating blanket, between the two metalslats. The heaters can be used either under or on top of the side - find which way is best for you, Turn on (heat) theheater's for a few minutes and bend the side in the machine in the normal way. Some builders continue to heat - atbelow maximum heat - the side for a while after the side is clamped into shape, and then let it cool down slowly beforefemoving it from the mold. The guitar bending heaters can also be used with a simple inside mold. place the heaters onthe side mold and heat it for 5 minutes or so. Place the moistened side on the heated blanket and clamp the waist areadown as it becomes pliable with the heat, After the waist is clamped into place in the waist of the mold push the sidesdown slowly around the upper and lower bouts. As the side bends around the mold's shape clamp it down with anyclamps available until the entire side is shaped around the mold.
Hot Tags: 220v rubber silicon heater bending, China, suppliers, manufacturers, factory, wholesale, price
